On Tue, 24 May 2005 09:54:02 -0400 (EDT), in
sentex.lists.freebsd.questions you wrote:
>Hello,
>
>I have an interesting question, I have a Pentium 4 2.4Ghz (No HT Enabled),
>2x80GB SATA Hard Drives in RAID 1. The box boots, works, etc. However,
>whenever you try and do an fsck -y, it says:
>
>[EMAIL PROTECTED](~)% fsck -y
>** /dev/twed0s1a (NO WRITE)
>** Last Mounted on /
Are you running fsck manually when the box is in multi-user mode ? If
so, thats your problem. What options do you have set in /etc/rc.conf
?
ie. what does
grep -i fsck /etc/rc.conf
grep -i fsck /etc/defaults/rc.conf
show ?
if you reboot and boot to single user mode and
run
fsck -a
what is the output ?
>Anyone got any ideas? I looked at www.3ware.com earlier and it says that
>the 8006-2LP's support FreeBSD 4.x, but not 5.x - could this be a result
>of that, seeing as otherwise the drives/RAID work fine (AFAIK, it could
>not be and I'm just not sure how to test it).
Its fully supported and works very well on 5.x. I have a number of
such cards deployed running RELENG_5. The website is just not up to
date.
---Mike
--------------------------------------------------------
Mike Tancsa, Sentex communications http://www.sentex.net
Providing Internet Access since 1994
[EMAIL PROTECTED], (http://www.tancsa.com)
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
