On 11/25/06 05:48, Ed P wrote:
Hi All
On 11/24/06, Peter Jeremy <[EMAIL PROTECTED]> wrote:
On Fri, 2006-Nov-24 18:53:28 -0600, Scott T. Hildreth wrote:
>"you need to set "libltdl_cv_sys_dlopen_deplibs=yes" in the environment
> before running the ./configure command."
>
>...does this apply to gnucash2 as well?
Yes.
> If I run strace on the process
>it just keeps spinning through the library search.
That's the problem that the above command fixes.
--
Peter Jeremy
I've installed Peter's port of GC 2 and aside from having to deal with
the above known libs issue, have had a great deal of success.
The port runs fine and seems quite stable, but I have found an issue
where transactions entered with memorized merchants will not accept
new dollar values. Instead the value of the previously entered
transaction for that merchant is entered instead. Once the
transaction is entered, the user can go back to the register and
change it - but this results in essentially entering transactions
twice.
I've posed the same question to gnucash-users with no answers. I also
installed and ran a GnuCash Linux livecd within a VMware VM and loaded
my data into it. The problem does not occur there.
Has anyone else had an issue like this?
I have seen something similar. And it is similar to something PJeremy@
once mentioned...
On occasion I can not delete a portion of a split transaction. It says
it is open elsewhere. Once that happens... I can no longer enter new
[memorized] transactions, as it does not remember them. If I then enter
the expense category, it will not accept any dollar value. I must
restart. It doesn't happen often, so not a big deal for me. Just
mentioning it as a "me too".
In general I am very pleased with gnucash2.
--
Regards,
Eric
_______________________________________________
freebsd-ports@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-ports
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
