On 5/19/07, Kian Mohageri <[EMAIL PROTECTED]> wrote:
On 5/18/07, Abdullah Ibn Hamad Al-Marri <[EMAIL PROTECTED]> wrote:
> On 5/18/07, Kian Mohageri <[EMAIL PROTECTED]> wrote:
> > On 5/18/07, Abdullah Ibn Hamad Al-Marri <[EMAIL PROTECTED]> wrote:
> > > On 5/18/07, Kian Mohageri <[EMAIL PROTECTED]> wrote:
> > > > On 5/18/07, Abdullah Ibn Hamad Al-Marri <[EMAIL PROTECTED]> wrote:
> > > > > Thank you for the tip.
> > > > >
> > > > > Here what I'm using which fixed the issue.
> > > > >
> > > > > pass in on $ext_if proto tcp from any to $ext_if port $tcp_services
> > > > > flags S/SA synproxy state
> > > > > pass in on $ext_if proto tcp from any to $ext_if port $tcp_services \
> > > > > flags S/SA keep state \
> > > > > (max-src-conn 30, max-src-conn-rate 30/3, \
> > > > > overload <bruteforce> flush global)
> > > > > pass out proto tcp to any keep state
> > > > >
> > > > > Comments?
> > > >
> > > > The first rule won't match anything (same criteria as second rule, and
> > > > last match wins with pf). On the third rule, use 'flags S/SA' unless
> > > > you have a good reason not to.
> > > >
> > > > Kian
> > > >
> > >
> > > I thought first rule will defeat syn flood.
> > >
> > > Is the second rule going to do the same job as first rule and will
> > > prevent syn flood?
> >
> > The rules are different obviously, but the criteria matches the same
> > traffic. Because PF will apply the last matching rule by default
> > (unless 'quick' is used), your first rule will never be applied. You
> > could use synproxy state on the second rule, and remove the first
> > entirely.
> >
> > > As for the third rule syntax, Should I make it like this?
> > >
> > > "pass out proto tcp to any flags S/SA keep state" and shall I add the
> > > same for udp?
> > >
> > > "pass out proto udp to any flags S/SA keep state" ?
> >
> > If you only want to pass UDP and TCP, then you can do something like this:
> >
> > pass out proto tcp to any flags S/SA keep state
> > pass out proto udp to any keep state
> >
> > Kian
> >
>
> Alright, can you give me synproxy in the first line entry? I tried to
> add it, and I get error.
No? I'm confused about what you're asking for. Paste what you tried first.
pass in on $ext_if proto tcp from any to $ext_if port $tcp_services \
flags S/SA synproxy state \
(max-src-conn 30, max-src-conn-rate 30/3, \
overload <bruteforce> flush global)
I added synproxy after S/SA to the rule but the rules didn't load and
says it's wrong.
--
Regards,
-Abdullah Ibn Hamad Al-Marri
Arab Portal
http://www.WeArab.Net/
_______________________________________________
freebsd-pf@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-pf
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
