I hope somebody on this list has more insights into this issue below.
NB: I can repeat the rtsol command and error from the command line. Regards, Ronald. Van: Ronald Klop via freebsd-arm <freebsd-...@freebsd.org> Datum: woensdag, 22 december 2021 14:53 Aan: freebsd-...@freebsd.org Onderwerp: ipv6 on genet0 + bridge not configuring
Hi, My RPI4 is running pretty happy with some VNET jails on it. # uname -a FreeBSD rpi4 14.0-CURRENT FreeBSD 14.0-CURRENT #15 main-9c0287e092: Fri Nov 5 10:48:20 CET 2021 ronald@rpi4:/home/ronald/dev/obj/home/ronald/dev/freebsd/arm64.aarch64/sys/GENERIC-NODEBUG arm64 # cat /etc/rc.conf hostname="rpi4" cloned_interfaces="bridge0" ifconfig_bridge0="addm genet0 SYNCDHCP" ifconfig_genet0="up" I now added this line to rc.conf: ifconfig_bridge0_ipv6="inet6 accept_rtadv" This does trigger some ipv6 negotiation on start up, but also some errors. bridge0: Ethernet address: 58:9c:fc:00:3e:aa Created cloe interfaces: bridge0. lo0: link state changed to UP genet0: link state changed to DOWN genet0: promiscuous mode enabled bridge0: link state changed to DOWN rtsol: cap_llflags_get() failed, anyway I'll try rtsol: sendmsg on bridge0: Can't assign requested address genet0: link state changed to UP bridge0: link state changed to UP rtsol: sendmsg on bridge0: Can't assign requested address rtsol: sendmsg on bridge0: Can't assign requested address Starting dhclient. Dhclient for ipv4 works well and assigns an address. Similar setup on another FreeBSD 14 works well with ipv6. But that does not have a bridge. It just enables IPv6 on the interface. What am I missing? Something obvious? Regards, Ronald.
