On Mon, Aug 27, 2018, at 17:13, Navdeep Parhar wrote: > On Mon, Aug 27, 2018 at 04:19:29PM +0200, Marius Halden wrote: > > Hi, > > > > We have some routers with Chelsio T540-CR NICs using 1Gbps SFPs (1000 > > Base-LX IIRC) to connect to our ISPs. After upgrading them to FreeBSD > > 11.2-p2 (BSDRP v1.91) we have run into some issues. When the machines > > are rebooted networking does not function at all through the ports > > connected with SFPs, ports connected with DAC cables work properly. > > According to ifconfig the SFPs are detected properly and they both > > What exact ifconfig command do you use to bring the interfaces up?
It's just the normal rc.conf lines with `ifconfig_cxl0="inet …"` and `ifconfig_cxl0_ipv6="inet6 …"`, nothing special beyond that. > Provide the output of these commands when the link isn't up: > # ifconfig -mvvv <interface> > # sysctl -n dev.t5nex.0.misc.devlog Thanks, I'll try these when I'm back at work tomorrow and report back. > > send and receive light as they should. If we remove the SFPs from the > > port and then reinsert them in the same port everything will start > > working as it should. > > > > Has anyone else observed this problem? Any suggestions for what can be > > done to solve/work around this issue without actually going to the > > datacenter would be great. > > Try ifconfig down/up instead of physically removing and then reinserting > the SFP module. Does that work? ifconfig down/up did not help, I tried that first (I should have mentioned it in the original email). Figuring out it would work by physically removing and reinserting the SFP was a side effect of initially trying to figure out if this was a hardware issue. -- Marius Halden _______________________________________________ freebsd-net@freebsd.org mailing list https://lists.freebsd.org/mailman/listinfo/freebsd-net To unsubscribe, send any mail to "freebsd-net-unsubscr...@freebsd.org"
