We just picked up 5 new HP DL 360p Gen8 E5-2630 2P servers … just installed
9.1-RELEASE, and it looks like all of the hardware is detected properly, and
being configured …
After reboot, I start getting the 'watchdog timeout - resetting' message on
bge0 … I've searched the web, and found the references to setting:
hw.bge.allow_asf="0"
hw.pci.enable_msi="0"
but after reboot with those set in /boot/loader.conf (and confirmed via sysctl
-a after login), its still doing it …
Looking at sysctl -a, even though:
hw.pci.enable_msi="0"
is set, I do see:
dev.bge.0.msi=1
dev.bge.1.msi=1
dev.bge.2.msi=1
dev.bge.3.msi=1
still all set to 1 … is that right?
Don't know if this is useful, but, again, according to sysctl -a:
dev.bge.0.%desc: Broadcom unknown BCM5719, ASIC rev. 0x5719001
===
If I do an 'ifconfig bge0', it does show the interface as being active, but I
can't ping out on it …
I even found someone's reference to doing a 'ifconfig bge0 -tso -vlanhwtso' and
tried that … no go …
Something else I can look at?
Thx
_______________________________________________
freebsd-net@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-net
To unsubscribe, send any mail to "freebsd-net-unsubscr...@freebsd.org"
