On Feb 7, 2013, at 4:13 PM, Ronald F. Guilmette <r...@tristatelogic.com> wrote:
> I just aquired a brand new chepie gigabit PCI ethernet card off eBay.
> The main chip on it appears to be an RTL8110S-32.
>
> I stuck this card into a 9.1-RELEASE system that I have been putting
> together, and it seemed to be recognized ok (as re0) upon boot up, so
> I diddled my /etc/rc.conf file to get it to ifconfig as 192.168.1.3
> on reboot. Then I rebooted.
>
> I have the card wired via a CAT6 cable to my Linksys E2000 gigabit
> router. Nonetheless, upon reboot, followed by "ifconfig -a", the
> output from ifconfig says the following for this card:
>
> re0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
>
> options=8209b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM,WOL_MAGIC,LINKSTATE>
> ether 00:13:3b:02:03:bd
> inet 192.168.1.3 netmask 0xffffff00 broadcast 192.168.1.255
> inet6 fe80::213:3bff:fe02:3bd%re0 prefixlen 64 scopeid 0x7
> nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>
> media: Ethernet autoselect (100baseTX <full-duplex>)
> status: active
>
> I've tried two different CAT6 cables, two different LAN ports on my E2000,
> and I've even tried the card in two different PCI slost on my motherboard,
> but the results are always the same.
>
> So, um, what gives? Why does the driver appear to be setting this card to
> 100baseTX rather than the 1000baseTX that I was hoping for?
>
> Is there some magic spell that I am unaware of that I must cast on this
> in order to get it to work right?
I would suspect the switch ("router"). FYI:
http://forum.qnap.com/viewtopic.php?f=11&t=47421#p213242
I have an re interface on my FreeBSD router and it connects at 1000baseT no
problem.
> P.S. dmesg has this to say about the card:
>
> re0: <RealTek 8169/8169S/8169SB(L)/8110S/8110SB(L) Gigabit Ethernet> port
> 0xbe00-0xbeff mem 0xdf9ff000-0xdf9ff0ff irq 18 at device 5.0 on pci4
> re0: Chip rev. 0x04000000
> re0: MAC rev. 0x00000000
> re0: Ethernet address: 00:13:3b:02:03:bd
> re0: link state changed to UP
> re0: link state changed to DOWN
> re0: link state changed to UP
> _______________________________________________
> freebsd-net@freebsd.org mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-net
> To unsubscribe, send any mail to "freebsd-net-unsubscr...@freebsd.org"
>
_______________________________________________
freebsd-net@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-net
To unsubscribe, send any mail to "freebsd-net-unsubscr...@freebsd.org"
