El día Tuesday, January 31, 2012 a las 11:53:48AM +0100, Milan Obuch escribió:
> Hi,
>
> I will test it later to see, but AFAIR this should be
> running/moving/live graph presentation of signal strength and data
> transfer (load/speed) done in ASCII, so a bit rough. Not as nice as
> done in 'properly graphical' way, but usable. If you have steady signal
> strength, it is not obvious, but when you move a bit, you could see the
> change. Just guessing now - # is for signal, v is download momentary
> speed and ^ is for upload.
Hi,
At the end I decided to understand the source code. Btw: the device port
/dev/cuaU0.n is hardcoded set to .2, while mine is .3 for the E1750;
the -51 dBm value is just nothing more than the best possible RSSI value
31;
the #-line (which is in real a fine line of some ncurses(3) symbol, don't
know why cut&paste changed this) is a scaled representation of the RSSI
values of the last 80x two seconds;
the byte value in line 13 of 400kB is always calculated as the max or RX
or TX values of the last 80x two seconds history;
and finally 'v' and '^' are used to represent the current RX or TX value
in scale with this maximum;
I will now watch this movie for a while and see if I can draw some clue
from that graphic :-)
matthias
--
Matthias Apitz
e <g...@unixarea.de> - w http://www.unixarea.de/
UNIX since V7 on PDP-11, UNIX on mainframe since ESER 1055 (IBM /370)
UNIX on x86 since SVR4.2 UnixWare 2.1.2, FreeBSD since 2.2.5
_______________________________________________
freebsd-net@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-net
To unsubscribe, send any mail to "freebsd-net-unsubscr...@freebsd.org"
