On Mon, Dec 05, 2011 at 05:02:45PM -0500, Arnaud Lacombe wrote: > Hi folks, > > FWIW, if any developers cares, I'm getting the same problem as Jukka > A. Ukkonen in [0], that is, an msk(4) interface stuck in: > > msk0: prefetch unit stuck? > msk0: initialization failed: no memory for Rx buffers >
If you upgraded from pre-r223396, try cold-boot. Note, you may have to completely remove power cord for a while before boot. The prefetch unit stuck message will show when RX checksum offloading initialization failed. If cold boot has no effect, try disabling RX checksum offloading. > hardware involved here is: > > # dmesg > [...] > mskc0: <Marvell Yukon 88E8053 Gigabit Ethernet> port 0xbe00-0xbeff mem > 0xfdefc000-0xfdefffff irq 16 at device 0.0 on pci1 > msk0: <Marvell Technology Group Ltd. Yukon EC Id 0xb6 Rev 0x02> on mskc0 > msk0: Ethernet address: 00:03:2d:09:94:3a > miibus0: <MII bus> on msk0 > > # pciconf -l > [...] > mskc0@pci0:1:0:0: class=0x020000 card=0x43401148 chip=0x436211ab > rev=0x19 hdr=0x00 > mskc1@pci0:2:0:0: class=0x020000 card=0x43401148 chip=0x436211ab > rev=0x19 hdr=0x00 > mskc2@pci0:3:0:0: class=0x020000 card=0x43401148 chip=0x436211ab > rev=0x19 hdr=0x00 > mskc3@pci0:4:0:0: class=0x020000 card=0x43401148 chip=0x436211ab > rev=0x19 hdr=0x00 > > Memory on the system is fine: > > # vmstat > procs memory page disk faults cpu > r b w avm fre flt re pi po fr sr ad0 in sy cs us sy id > 0 0 0 52844K 1957M 0 0 0 0 0 0 0 51 34 4044 0 0 100 > > # netstat -m > 719/946/1665 mbufs in use (current/cache/total) > 717/825/1542/262144 mbuf clusters in use (current/cache/total/max) > 717/819 mbuf+clusters out of packet secondary zone in use (current/cache) > 0/5/5/131072 4k (page size) jumbo clusters in use (current/cache/total/max) > 0/0/0/65536 9k jumbo clusters in use (current/cache/total/max) > 0/0/0/32768 16k jumbo clusters in use (current/cache/total/max) > 1613K/1906K/3520K bytes allocated to network (current/cache/total) > 0/0/0 requests for mbufs denied (mbufs/clusters/mbuf+clusters) > 0/0/0 requests for jumbo clusters denied (4k/9k/16k) > 0/3/6656 sfbufs in use (current/peak/max) > 0 requests for sfbufs denied > 0 requests for sfbufs delayed > 0 requests for I/O initiated by sendfile > 0 calls to protocol drain routines > > Faulty code is from 8-STABLE, i386, locally built with FLOWTABLES and > ROUTETABLES=8. Jukka's report seems to point out that -current is no > better. > > Problem happened after a few minutes of not-so-heavy transfer. > > - Arnaud > > [0]: > http://lists.freebsd.org/pipermail/freebsd-questions/2011-November/235646.html _______________________________________________ freebsd-net@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-net To unsubscribe, send any mail to "freebsd-net-unsubscr...@freebsd.org"
