11.01.2011 21:48, Bjoern A. Zeeb пишет:
On Tue, 11 Jan 2011, Artyom Viklenko wrote:
11.01.2011 21:29, Lev Serebryakov ?????:
r...@rescue ~ # mii-tool -v eth0
eth0: 100 Mbit, full duplex, link ok
product info: vendor 00:07:32, model 17 rev 2
basic mode: 100 Mbit, full duplex
basic status: link ok
capabilities: 1000baseT-HD 1000baseT-FD 100baseTx-FD 100baseTx-HD 10baseT-FD
10baseT-HD
advertising: 100baseTx-FD 100baseTx-HD 10baseT-FD 10baseT-HD flow-control
link partner: 100baseTx-HD
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Looks very strange for me... 'HD' means half-duplex?
May be linux driver defaults to full-duplex if autoneg fails?..
That's probably just because it cannot tell what the peer really uses
(autoneg disabled) and prints the sane fall-back but I don't know the code.
Is it possible to see status from corresponding port on Juniper switch?
Config part for this port on the switch would be also very interesting.
--
Sincerely yours,
Artyom Viklenko.
-------------------------------------------------------
[email protected] | http://www.aws-net.org.ua/~artem
[email protected] | JID: [email protected]
FreeBSD: The Power to Serve - http://www.freebsd.org
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-net
To unsubscribe, send any mail to "[email protected]"
