On Fri, October 1, 2010 5:38 am, Hiroki Sato wrote:
> Dan Langille <d...@langille.org> wrote
> in <4ca55041.7040...@langille.org>:
>
> da> # cat /etc/rtadvd.conf
> da> fxp1:\
> da> :addrs#1:addr="2001:470:1f07:b80::":prefixlen#64:tc=ether:
>
> In this case, you do not need rtadvd.conf. The command line "rtadvd
> fxp1" should work fine.
I have removed the .conf and restarted rtadvd
> da> Where: fxp1 is on my internal LAN which has 2001:470:1f07:b80::1 as an
> da> IP address. (you should be able to ping6 that).
>
> Can you show the results of "ifconfig fxp1"?
# ifconfig fxp1
fxp1: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
options=9<RXCSUM,VLAN_MTU>
ether 00:04:ac:d3:70:12
inet 10.55.0.1 netmask 0xffffff00 broadcast 10.55.0.255
inet6 2001:470:1f07:b80::1 prefixlen 64
nd6 options=3<PERFORMNUD,ACCEPT_RTADV>
media: Ethernet autoselect (100baseTX <full-duplex>)
status: active
>
> Dan Langille <d...@langille.org> wrote
> in <4ca55725.10...@langille.org>:
>
> da> After I issued this command on the server:
> da>
> da> # route -n add -inet6 2001:470:1f07:b80::/64 -interface fxp1
> da> add net 2001:470:1f07:b80::/64: gateway fxp1
>
> I do not think this is needed if you did "ifconfig fxp1 inet6
> 2001:470:1f07:b80::1/64".
>
> Dan Langille <d...@langille.org> wrote
> in <4ca56123.2030...@langille.org>:
>
> da> However, clients on my LAN are unable to get any IPv6 routing
> da> information despite having ipv6_enable="YES" in /etc/rc.conf.
>
> What is displayed when entering the following commands?
>
> # ifconfig em0
> # sysctl net.inet6.ip6.accept_rtadv
# ifconfig em0
em0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
options=219b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM,TSO4,WOL_MAGIC>
ether 00:1b:21:51:ab:2d
inet 10.55.0.44 netmask 0xffffff00 broadcast 10.55.0.255
inet6 fe80::21b:21ff:fe51:ab2d%em0 prefixlen 64 scopeid 0x1
nd6 options=3<PERFORMNUD,ACCEPT_RTADV>
media: Ethernet autoselect (100baseTX <full-duplex>)
status: active
# sysctl net.inet6.ip6.accept_rtadv
net.inet6.ip6.accept_rtadv: 1
This is after running netsol em0
--
Dan Langille -- http://langille.org/
_______________________________________________
freebsd-net@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-net
To unsubscribe, send any mail to "freebsd-net-unsubscr...@freebsd.org"
