On Sun, Feb 21, 2010 at 11:28:54AM +0100, Patrick Ale wrote: > Good morning! > > On Tue, Feb 16, 2010 at 7:35 PM, Pyun YongHyeon <pyu...@gmail.com> wrote: > > > I assume you're using age(4). > > age(4) is one of driver that still does full re-initialization while > > dhclient(8) is running, how about unplugging the UTP cable and > > replug it while DHCP is in progress? > > Actually it is the 'ale' driver (kinda funny when you look at my last > name ;-) ).. > And yes, you are right. When during the instalation I provide a static > IP address, the link comes up and I have TCP/IP connectivity. DHCP > always fails with 'no link' errors. > > >
After you see the failure DHCP, unplug the UTP cable and wait 2-3 seconds and replug the UTP cable again. And execute "dhclient ale0", does it make any difference? > > There are several variants of L1 so please show me the dmesg > > output. > > This is a 'dmesg | grep ale' output when I configure a static IP address: > > ale0: <Atheros AR8121/AR8113/AR8114 PCIe Ethernet> port 0x3000-0x307f > mem 0xf6000000-0xf603ffff irq 16 at device 0.0 on pci2 > ale0: 960 Tx FIFO, 1024 Rx FIFO > ale0: Using 1 MSI messages. > ale0: 4GB boundary crossed, switching to 32bit DMA addressing mode. > miibus0: <MII bus> on ale0 > ale0: Ethernet address: 00:a0:d1:a5:b8:9a > ale0: [FILTER] > ale0: link state changed to UP > It seems you've removed PHY driver related message here. Show me the output of "devinfo -rv | grep phy". Also show me the output of "pciconf -lcv". > > So for now it is workable but I'd like to find out why DHCP is failing > and if I can help out trying to figure out what is going on :) > Last time I tried ale(4) it worked as expected. I have no longer access to ale(4) hardware so it would be hard to fix that but I'll see what I can do. > Thanks all for your time, > > Patrick _______________________________________________ freebsd-net@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-net To unsubscribe, send any mail to "freebsd-net-unsubscr...@freebsd.org"
