Sten, good day. Thu, May 17, 2007 at 01:04:29PM +0200, Sten Daniel Soersdal wrote: > >I have the '82540EM Gigabit Ethernet Controller' branded card > >(PWLA8390MT) and I am currently expiriencing troubles with the > >Gigabit switch (D-Link DGS-1008, the cheap one). Plugged into that > >switch I have > > - broken packets and SSH messages 'Disconnecting: Corrupted MAC > > on input.' when checksumming is turned on and gigabit speed, > > - abyssmal rates for the HTTP downloads (about 10Mbit/sec) when > > checksums are turned off and the speed is gigabit again, > > - having switched the media on the adapter to the 100BaseTX > > full-duplex, but still using the same switch the speed drops to > > 200Kbit/sec, > > - using another D-Link switch (sorry, have no other brand in > > hand) the above situation is completely reproducible. > > - working in the half-duplex mode (for 10BaseT/UTP and 100BaseTX) > > I have no problems to reach the 90% of the theoretical bandwidth > > of the link via HTTP either with checksums enabled or disabled. > >So, the full-duplex mode is not usable to me now. If someone can > >help in this situation, I am all ears. > > That's what we call a self inflicted network problem. > When one end is configured full-duplex and the other end is in auto > speed/duplex and you want to set fixed speed/duplex, then you need to do it on > both ends. Otherwise the auto-negotiating side will default to half-duplex. > This is to be backwards compatible with hubs.
If I am correct, there is no such thing as the fixed speed/duplex for the 1000Base-TX: it always auto-negotiates. Moreover, I just bough the 10/100 D-Link ;)) switch and plugged my card into it saying just 'media 100BaseTX'. No problems: full duplex mode and no errors. 'media 100BaseTX mediaopt full-duplex' and 'media autoselect' all resulted to full-duplex and no errors. Redid my tests with varying speed/duplex and the Gbit switch: - 'media 100baseTX mediaopt full-duplex': no errors, small speed (1 Mbit), - 'media 100baseTX' (got full-duplex): the same, - 'media 1000Base-TX': 'Corrupted MAC on input'. - 'media autoselect' (got 1000Base-TX): 'Corrupted MAC on input'. - 'media 100baseTX' (got _half-duplex_): no errors, good speed. - 'media 100baseTX mediaopt full-duplex': small speed (1Mbit), no errors. So there is something with the Gbit ports and maybe D-Link hardware that stimulates the errors for the 1000Base-TX. And you're right: the slowness for the 10/100 full-duplex modes with Gbit switch can be attributed to the duplex mismatch. The funny thing that I have no problems to negotiate/set the duplex for the 10/100 modes and 10/100 switch. To my regret, I have no means to force the speed/duplex on the switches: they are too inexpensive for that. Thank you. -- Eygene _______________________________________________ freebsd-net@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-net To unsubscribe, send any mail to "[EMAIL PROTECTED]"