On Thu, Dec 14, 2006 at 07:05:04PM -0800, Ask Bj?rn Hansen wrote: A> Hi, A> A> If I enable carp on a vlan interface in rc.conf the kernel goes A> boom. This is 6.2-RC from a couple of weeks ago. (IIRC then I had A> the same problem setting up carp on a bridge'd interface). A> A> I'm configuring it like this: A> A> ifconfig_vlan2="inet 10.50.0.3/24 vlan 202 vlandev sis2" A> ifconfig_carp2="vhid 3 advskew 200 pass awe4jkfha4jkfha4f 10.50.0.1" A> A> cloned_interfaces="... carp2 ... vlan2" A> A> However, if I do the carp2 setup "manually" after the system is A> booted, it is working fine. A> A> ifconfig carp2 vhid 3 advskew 200 pass hjarefhakjewfha 10.50.0.1 A> A> Any ideas? A> A> (kernel dump below) A> A> - ask A> A> A> fault virtual address = 0x100005c A> fault code = supervisor read, page not present A> instruction pointer = 0x20:0xc05ba533 A> stack pointer = 0x28:0xc7975c30 A> frame pointer = 0x28:0xc7975c90 A> code segment = base 0x0, limit 0xfffff, type 0x1b A> = DPL 0, pres 1, def32 1, gran 1 A> processor eflags = interrupt enabled, resume, IOPL = 0 A> current process = 13 (swi1: net) A> trap number = 12 A> panic: page fault A> Uptime: 17s A> Cannot dump. No dump device defined.
Can you please configure dump device, obtain kernel dump, and print the backtrace from it? -- Totus tuus, Glebius. GLEBIUS-RIPN GLEB-RIPE _______________________________________________ freebsd-net@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-net To unsubscribe, send any mail to "[EMAIL PROTECTED]"
