Hi,
I am running a FreeBSD 5.4 stable as a network router.
I don't know any reason why one of the ethernet ports becomes half-duplex.
Here is its detail:
em1: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
options=b<RXCSUM,TXCSUM,VLAN_MTU>
inet 60.1.2.3 netmask 0xfffffffc broadcast 220.233.99.39
ether 00:04:23:bc:3a:d1
media: Ethernet autoselect (10baseT/UTP <half-duplex>)
status: active
em2: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
options=b<RXCSUM,TXCSUM,VLAN_MTU>
inet 10.1.10.1 netmask 0xffffff00 broadcast 10.1.10.255
ether 00:04:23:bc:3a:d2
media: Ethernet autoselect (1000baseTX <full-duplex>)
status: active
This network card is a Quat Port Intel card.
Is there any way I can "reset" it to full-duplex and 1000baseT without close
down the network connection on em1?
I know I can use following command to change it:
ifconfig em1 media 100baseTX mediaopt full-duplex
but if this not work, it will close down the entire internet connection,
which I try to avoid.
Thanks
S
_______________________________________________
freebsd-net@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-net
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
