On Thu, Aug 17, 2006 at 06:21:50PM +0530, [EMAIL PROTECTED] wrote: s> I have bge and fxp interface on the system. I enabled the NETGRAPH by s> enabling the NETGRAPH in the config file and compiled the new kernel. s> Then, booted with the new kernel. s> s> s> fxp0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500 s> options=8<VLAN_MTU> s> inet6 fe80::290:27ff:fe85:8b8c%fxp0 prefixlen 64 scopeid 0x1 s> inet 17.1.1.150 netmask 0xff000000 broadcast 17.255.255.255 s> ether 00:90:27:85:8b:8c s> media: Ethernet autoselect (none) s> status: no carrier s> s> bge0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500 s> options=1a<TXCSUM,VLAN_MTU,VLAN_HWTAGGING> s> inet6 fe80::2e0:81ff:fe29:f38d%bge0 prefixlen 64 scopeid 0x3 s> inet 10.114.52.152 netmask 0xffffff00 broadcast 10.114.52.255 s> ether 00:e0:81:29:f3:8d s> media: Ethernet autoselect (100baseTX <full-duplex>) s> status: active s> s> Even then I could not see the above interfaces listed in the output of s> the list command of ngctl. s> s> + list -l s> There are 2 total nodes: s> Name: ngctl1088 Type: socket ID: 00000007 Num hooks: s> 0 s> Name: <unnamed> Type: eiface ID: 00000004 Num hooks: s> 0 s> + list -n s> There are 1 total named nodes: s> Name: ngctl1088 Type: socket ID: 00000007 Num hooks: s> 0 s> + s> s> s> But as per the document in the below link it is mentioned that network s> interface by default should be listed in the output. s> http://ezine.daemonnews.org/200003/netgraph.html s> s> Is that means these drivers are not supporting the netgraph?
No. You need either kldload ng_ether or add NETGRAPH_ETHER to kernel config. -- Totus tuus, Glebius. GLEBIUS-RIPN GLEB-RIPE _______________________________________________ freebsd-net@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-net To unsubscribe, send any mail to "[EMAIL PROTECTED]"
