sfp wrote this message on Tue, May 16, 2006 at 22:22 -0600:
> From: "Oliver Fromme" <[EMAIL PROTECTED]>
>
> > sfp <[EMAIL PROTECTED]> wrote:
> > > Is it possible to disable a driver compiled into a 4.10 kernel at
> > > boot time by feeding a (set?) command to the loader?
> > >
> > > In this case I want to turf the EM(4) driver that was compiled into
> > > the kernel I've inherited and substitute it with a new if_em.ko using
> > > kldload.
> >
> > That's not possible. You might disable a driver through
> > loader variables (or kernel hints, or whatever), but the
> > driver will still be present in the kernel image, so you
> > cannot load a module that uses the same symbols.
>
> I may have answered my own question. Compiled em-4.1.6, replaced if_em.ko
> & loaded it from /boot/loader.conf.
>
> The reason I need this is 4.10 enumerates the Pro/1000 GT (PWLA8391GT,
> 82541PI chipset) as unknown. Need a newer driver to support the hardware.
>
> I'd still like to find a way to suppress the driver in the kernel entirely
> though :P
Since the kernel driver it's attaching, you could always rename the
em module that you compile... just a few things to change, and you
have a different name, and no conflicts w/ the kernel...
--
John-Mark Gurney Voice: +1 415 225 5579
"All that I will do, has been done, All that I have, has not."
_______________________________________________
freebsd-net@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-net
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
