Zongsheng Zhang wrote:
I have confirmed that there is no problem with settings of Dummynet.
When Host-A/B uses Linux, the throughput of RTT=20ms (using Iperf) is
same as that of RTT=0ms.
Host-A/B use FreeBSD v6.0 release. Does anyone have
experience/suggestion for achieving high throughput with FreeBSD?
In June 2005, a former fellow-student and me did such tests using
FreeBSD 5.4. Our test setup was the same as yours. We used three Dell
Poweredge 1850's (iirc) with dual Xeon processors, PCI-X gbit 'em'
interfaces and we used iperf too. Performance was terrible with high
RTT's. We tried all kinds of things: SMP or UP kernels, polling (and
it's settings), fiddling with HZ on the dummynet-host, lowering and
raising the IP input queue maxlen, etc.
In the end we pinged the sending host over it's external/non-test
interface. We saw enormous packet loss and latency up to 5 -seconds-.
This lead us to believe the TCP or socket buffer code (but probably the
former, since the socket buffer is appended to using a simple tail
pointer) was that inefficient that the kernel wasn't doing much else
than sending TCP packets. Sadly, we did not have any time to research it
any more.
Perhaps Andre Opperman can shed some light on this, seeing as he's
hacking away at the TCP/IP code now.. In any case, when his work is
committed, you should have a lot more performance :)
--
Pieter
_______________________________________________
freebsd-net@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-net
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
