Hi list,
I have just installed freevrrp in FreeBSD5.4 (pre-release) with the following setup:
#public-facing VRID
[VRID]
serverid = 1
interface = fxp0
priority = 255
addr = 198.168.4.1/32
#password = vrid1
#vridsdep = 2
# backend VRID
[VRID]
serverid = 1
interface = em0
priority = 255
addr = 192.168.1.1/32
#password = vrid2
#vridsdep = 1
However, the virtual IP 192.168.4.1 (on fxp0) is not reachable with ping, while another virtual IP 192.168.1.1 (on em0) is fine.
Here is the result from ifconfig:
# ifconfig
em0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
options=b<RXCSUM,TXCSUM,VLAN_MTU>
inet 192.168.1.253 netmask 0xffffff00 broadcast 192.168.1.255
inet6 fe80::20e:cff:fe05:8229%em0 prefixlen 64 scopeid 0x1
inet 192.168.1.1 netmask 0xffffffff broadcast 192.168.1.1
ether 00:00:5e:00:01:01
media: Ethernet autoselect (100baseTX <full-duplex>)
status: active
fxp0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
options=8<VLAN_MTU>
inet 192.168.4.253 netmask 0xffffff00 broadcast 192.168.4.255
inet6 fe80::211:11ff:fe0f:9543%fxp0 prefixlen 64 scopeid 0x2
inet 192.168.4.2 netmask 0xffffff00 broadcast 192.168.4.255
inet 198.168.4.1 netmask 0xffffff00 broadcast 198.168.4.255
ether 00:00:5e:00:01:01
media: Ethernet autoselect (100baseTX <full-duplex>)
status: active
plip0: flags=108810<POINTOPOINT,SIMPLEX,MULTICAST> mtu 1500
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 16384
inet 127.0.0.1 netmask 0xff000000
inet6 ::1 prefixlen 128
inet6 fe80::1%lo0 prefixlen 64 scopeid 0x4
pfsync0: flags=41<UP,RUNNING> mtu 2020
pflog0: flags=41<UP,RUNNING> mtu 33208
in /etc/rc.conf:
gateway_enable="yes"
defaultrouter="192.168.4.254"
hostname="gateway.home.com"
ifconfig_fxp0="inet 192.168.4.253 netmask 255.255.255.0"
ifconfig_fxp0_alias0="inet 192.168.4.2 netmask 255.255.255.0"
ifconfig_em0="inet 192.168.1.253 netmask 255.255.255.0"
result from netstat -rn:
Internet:
Destination Gateway Flags Refs Use Netif Expire
default 192.168.4.254 UGS 0 0 fxp0
127.0.0.1 127.0.0.1 UH 0 60 lo0
192.168.1 link#1 UC 0 0 em0
192.168.1.1/32 link#1 UC 0 0 em0
192.168.4 link#2 UC 0 0 fxp0
192.168.4.2 00:00:5e:00:01:01 UHLW 0 6 lo0
192.168.4.254 00:02:b3:0b:3c:d1 UHLW 0 257 fxp0 606
198.168.4 link#2 UC 0 0 fxp0
What should I do to make virtual address 192.168.4.1 reachable from local and external ping?
Thanks
Sam.
_______________________________________________ freebsd-net@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-net To unsubscribe, send any mail to "[EMAIL PROTECTED]"
