--On Thursday, December 23, 2004 13:25:16 +0900 Sangwoo Shim <[EMAIL
PROTECTED]> wrote:
On Wed, Dec 22, 2004 at 07:15:16PM -0800, Pat Lashley wrote:
[snip]
Now that that's out of the way, Sangwoo, could you post the details
of your dubp + ng_eiface solution? I might want to switch to that.
-Pat
Ah, I don't have the YOPY anymore. So I can't describe every detail.
But the outline was:
1. Add YOPY's device id/vendor id to USB_MATCH() of /sys/dev/usb/udbp.c.
(I cannot recall the exact values, but it can be discovered by usbdevs -v
or looking at Linux's usbnet driver's header.)
Already have it from my tweaks to the if_cdce driver. For those who
might be following this thread, here are the values for my YP 3700:
Vendor 0x22b8
Product 0x4902
Release 0x0001
Class 0x0002
Subclass 0x0000
Protocol 0x0000
The Vendor and Product are the only values necessary for the driver;
and I suspect that in this case, there's no real advantage to specifying
any of the others in usbd.conf.
For completeness, I would be interested in obtaining values for the
YP 3500 and YP 3000.
2. Recompile udbp.ko and kldload it.
(do 'make all install' in /sys/modules/udbp)
3. kldload ng_eiface.ko.
4. Create ng_eiface node and connect it to the data hook of the udbp node.
e.g. do 'ngctl mkpeer udbp0: eiface data ether'
5. Set ngethX appropriately. (using ifconfig).
This gave me over 400KB/s ftp connection.
You could send a PR in udbp also, I suppose? :-)
Thanks, I'll give that a try after the holidays. If I wind up going
that route instead of cdce, I will submit a PR with the YOPY's values.
-Pat
_______________________________________________
freebsd-net@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-net
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
