on Wed, 20 Oct 2004 07:53:28 -0700, Yong Chu Eu <[EMAIL PROTECTED]> said: > > i am try to stream from freeBSD multicast router(without kame but with > pim6sd,route6d)to MN throught Access Point which are redhat. There is a > bridge between eth0 and wlan0 at software Access Point. There problem is i > cannot even start streaming from vls, the error message i paste as below . > I can do streaming on IPV4/IPv6 unicast.
I have not used vls, so I defer to anyone that can offer better suggestions. I don't see anything in the on-line documentations about known IPv6 multicast problems or how to interpret the Net6Output error message. Have you tried to IPv4 multicast? From the vls documentation is configured: BEGIN "multicast1" # multicast streaming Type = "multicast" DstHost = "239.2.12.42" DstPort = "1234" TTL = "64" END I am assuming the Linux PC Access Point is a bridge mode, not routing, so a IPv4 mrouted (DVMRP) or pimd (PIM) is not needed; though FreeBSD will only send the multicast packets out one of the interfaces without a IPv6 multicast router. The other suggestion is to turn on the verbose debugging, it may shed light on the multicast problem. --Mark Tinguely _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-net To unsubscribe, send any mail to "[EMAIL PROTECTED]"
