I've got a bit of a mystery when I have the below picture fxp1 10.1.x.x/22 ______|___ 10.1.x.x/22 |device|-------|switch| ---------| bridge | -----------|targ| fxp2 fxp0
arp replies from the target are not being forwarded to fxp2 if I remove the switch (a cisco cat) and go to the picture below fxp1 10.1.x.x/22 ______|___ 10.1.x.x/22 |device|-------------------------| bridge | -----------|targ| x-over cable fxp2 fxp0 the arp replies are recieved just fine. I've tried both 5.2.1-p8 and 5.2-current. Additionally, if targ is a bsd box things are OK, but if targ is a unixware box which it needs to be, bzzzzt. ------------ net.link.ether.bridge_cfg=fxp0,fxp2 net.link.ether.bridge.enable=1 I've tried both net.inet.ip.check_interface=[0|1] ifconfig_fxp0="inet 10.1.X.X netmask 255.255.252.0 media 100basetx mediaopt full-duplex" ifconfig_fxp2="media 100basetx mediaopt full-duplex" ifconfig_fxp1="inet 10.5.Y.Y netmask 255.255.255.0 media 100basetx mediaopt full-duplex" any insights or I ideas? -- Email: [EMAIL PROTECTED] ICQ: 93234105 -- -- When things can't get any worse, they simplify themselves by getting a whole lot worse then complicated. A complete and utter disaster is the simplest thing in the world; it's preventing one that's complex. (Janet Morris) _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-net To unsubscribe, send any mail to "[EMAIL PROTECTED]"