Good day all, In my infinite striving towards perfection *cough* I've gone through a lot of hoops to get ng_fec working for (at least for the time being) the bge interfaces (not that I understand it really yet). Now, being limited in the number of interfaces available to me on this project, I'm attempting to attach vlans to the fec interface, with no signs of success, up to this point.
I have two dell 1750's connected to a c3750 switch. FEC works with ip addresses attached to the fec0 interfaces (although, single connections seem to remain on one link or the other, I haven't played with the load-balancing on the switch yet for the channel group, might be my fault). My questions are: 1) Is is even possible to successfully "attach" vlan devices to netgraph nodes, specifically the ng_fec node (I can't decipher enough of netgraph to begin with to make a guess, just a copy monkey here...), i.e. have interface fec the parent device? 2) Is the correct way on the Cisco side to configure interfaces in the FEC group as trunks, _or_ group them as access ports, and make the FEC group a trunk? (I haven't read exhaustively on this, seems to be some descrepency between CatOS and IOS on this anyway...) btw, with a few more hints, I could get a manpage up... I have patches to attach it to the world build as well, compiles fine on 4.8-R, fwiw. -- Med vennlig hilsen/Sincerely, Shaun D. Jurrens Drift og Sikkerhetskonsulent IKT-Avdeling Oslo Skoleetaten gpg key fingerprint: 007A B6BD 8B1B BAB9 C583 2D19 3A7F 4A3E F83E 84AE
pgp00000.pgp
Description: PGP signature
