I was wondering how to modify the appropriate files to setup a FreeBSD computer to act as a NAT Router, that would do the following:
One NIC card is connected to a private network, with an IP address of 192.168.0.50. This will act as the gateway to all the computers in the technology center, to connect to the internet (Nic Card 2, Provided by Cox) and to the SDSU connection (Nic Card 3). We need the NAT Router to act as follows: 1) When computers of the private network access the general internet, we need the NAT to translate to the Cox.Net IP, except for all addresses beginning with 130.191.X.X or 146.244.X.X, or all traffic on port 1214 (KaZaa), which we need to go the SDSU Connection. 2) When the IP Address the data is going to begins with 146.244.X.X or 130.191.X.X, or any IP address using port 1214, we need the data to route through the SDSU IP Address. NIC Card Info: Nic Card 1 (Private Network): IP: 192.168.0.1 Subnet: 255.255.255.0 Gateway: 192.168.0.1 DNS: 192.168.0.2 Nic Card 2 (Cox Network): IP: 68.15.25.98 Subnet: 255.255.252.0 Gateway: 68.15.25.65 DNS: 209.242.128.107 DNS2: 209.242.128.101 NIC Card 3 (SDSU TNS Network): IP: 130.191.73.13 Subnet: 255.255.255.0 Gateway: 130.191.73.254 DNS: 130.191.1.1 DNS2: 130.191.200.1 If someone could give us step-by-step instructions to configure this, it would be appreciated. Stephen -------------------------------------------------------------------- mail2web - Check your email from the web at http://mail2web.com/ . _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-net To unsubscribe, send any mail to "[EMAIL PROTECTED]"
