I have merged in some additional updates provided by Paul Saab: - Support the BCM5782 chip (5705 workalike, new PCI ID) - Increase firmware handshake timeout - Always check for GMII PHYs at PHY address 1 (required for some chips, doesn't hurt on the others) - Add ASIC rev numbers for 5705_A1, 5705_A2 and 5705_A3
There may be some additional performance tweaks needed, but this should get the device attached and working. As before, download the new code from: http://www.freebsd.org/~wpaul/Broadcom/5705 - Copy if_bge.c and if_bgereg.h to /sys/dev/bge - Copy miidevs and brgphy.c to /sys/dev/mii - Rebuild your kernel and/or if_bge.ko and miibus.ko modules -Bill -- ============================================================================= -Bill Paul (510) 749-2329 | Senior Engineer, Master of Unix-Fu [EMAIL PROTECTED] | Wind River Systems ============================================================================= "If stupidity were a handicap, you'd have the best parking spot." ============================================================================= _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-net To unsubscribe, send any mail to "[EMAIL PROTECTED]"
