> Where could I get the errata sheet? Product Specification Updates i.e. errata, and the Product Specification itself are available from Intel under a Non Disclosure Agreement. Unless you work for a company that is doing business with Intel, they are probably not obtainable. > > Could the numbers be packet thresholds? 28 and 128 packets respectively? > I can't answer that directly because of NDA. Let us apply some logic here. If they were packet counts, under very low load conditions e.g. a single telnet session, the telnet link would be unusable. This leads us to the conclusion that they must be time values.
Jim > Anything else that can be done? Does PCI width/speed affect the amount of > time spent in the kernel interrupt or are the PCI transfers asynchronous? > > Pete > > ----- Original Message ----- > From: "Jim McGrath" <[EMAIL PROTECTED]> > To: "Luigi Rizzo" <[EMAIL PROTECTED]>; "Petri Helenius" <[EMAIL PROTECTED]> > Cc: "Lars Eggert" <[EMAIL PROTECTED]>; <[EMAIL PROTECTED]> > Sent: Friday, October 18, 2002 7:49 AM > Subject: RE: ENOBUFS > > > > Careful here. Read the errata sheet!! I do not believe the em > driver uses > > these parameters, and possibly for a good reason. > > > > Jim > > > > > -----Original Message----- > > > From: [EMAIL PROTECTED] > > > [mailto:owner-freebsd-net@;FreeBSD.ORG]On Behalf Of Luigi Rizzo > > > Sent: Thursday, October 17, 2002 11:12 PM > > > To: Petri Helenius > > > Cc: Lars Eggert; [EMAIL PROTECTED] > > > Subject: Re: ENOBUFS > > > > > > > > > On Thu, Oct 17, 2002 at 11:55:24PM +0300, Petri Helenius wrote: > > > ... > > > > I seem to get about 5-6 packets on an interrupt. Is this tunable? At > > > > > > just reading the source code, yes, it appears that the card has > > > support for delayed rx/tx interrupts -- see RIDV and TIDV definitions > > > and usage in sys/dev/em/* . I don't know in what units are the values > > > (28 and 128, respectively), but it does appear that tx interrupts are > > > delayed a bit more than rx interrupts. > > > > > > They are not user-configurable at the moment though, you need > to rebuild > > > the kernel. > > > > > > cheers > > > luigi > > > > > > > 50kpps the card generates 10k interrupts a second. Sending generates > > > > way less. This is about 300Mbps so with the average packet size of > > > > 750 there should be room for more packets on the interface queue > > > > before needing to service an interrupt? > > > > > > > > What´s the way to access kernel adapter-structure? Is there > an utility > > > > that can view the values there? > > > > > > > > > Pete > > > > > > > > > > > > > > To Unsubscribe: send mail to [EMAIL PROTECTED] > > > with "unsubscribe freebsd-net" in the body of the message > > > > > > > > > To Unsubscribe: send mail to [EMAIL PROTECTED] with "unsubscribe freebsd-net" in the body of the message