Bge detects the card and it shows up on ifconfig it does not detect
1000basetx on autoselect even though the card and the switch both register
1000baset. I connected it to a 100base t port and it seems to work fine. How
do I get it to switch to 1000baset
This is the bge section of ifconfig
bge0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
options=3<rxcsum,txcsum>
inet 192.168.0.166 netmask 0xffffff00 broadcast 192.168.0.255
inet6 fe80::204:76ff:fee0:12a9%bge0 prefixlen 64 scopeid 0x1
ether 00:04:76:e0:12:a9
media: Ethernet autoselect (100baseTX <full-duplex>)
status: active
Jeff
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On
Behalf Of Jesper Skriver
Sent: Friday, February 22, 2002 5:53 PM
To: Jeff Lawton
Cc: [EMAIL PROTECTED]
Subject: Re: FW: 3com gigabit 3c996b-t
On Fri, Feb 22, 2002 at 05:41:03PM -0500, Jeff Lawton wrote:
> I am having trouble getting a 3com 3c996b-t to installed correctly. Is
> here a reference on how to properly set up the bge(4) driver. I am
> useing 4.5 release
If you told what the problem was, it would be a whole lot easier to help
...
/Jesper
--
Jesper Skriver, jesper(at)skriver(dot)dk - CCIE #5456
Work: Network manager @ AS3292 (Tele Danmark DataNetworks)
Private: FreeBSD committer @ AS2109 (A much smaller network ;-)
One Unix to rule them all, One Resolver to find them,
One IP to bring them all and in the zone to bind them.
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-net" in the body of the message
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-net" in the body of the message
