Thor Legvold writes:
> Still debugging, some questions to verify I have the proper config.
>
> FBSD dual homed host/gw for a home LAN
> dc0 home LAN 192.168.128.0/24
> wi0 ISP WAN 10.10.0.0/16
>
> IPFW and NAT are running, ipfw is wide open at present, natd running -m -s
> -dynamic on wi0. Don't know if I need anything else special on nat for PPTP
> to work.
>
> My ISP has a pool of dynamically assignable (DHCP) routable IP's that they
> assign via a PPTP server at 10.10.1.1. The routable IP's are in the range
> 213.225.121.0/24 as far as I understand.
>
> My config looks like this:
>
> # mpd.conf
> access:
> new -i ng0 access access
> set iface idle 0
> set iface route default
> set iface disable on-demand
> set bundle disable multilink
> set bundle authname "myreallogin"
> set bundle password "myrealpassword"
> set link yes pap
> set link yes chap
Replace "yes" with "allow" in the above two lines.
> set link no mppc
Not a valid command.. maybe you mean 'set ccp no mppc' ?
> set link disable no-orig-auth
> set ipcp ranges 0.0.0.0/0 10.10.1.1/0
> and links like this:
>
> # mpd.links
> access:
> set link type pptp
> set pptp mode active
> set pptp peer 10.10.1.1
> set pptp enable originate outcall
> Does this appear at all correct? My ISP knows a bit about Linux (they use it
> for the PPTP/VPN server, running PoPToP), and said I needed a "name"
> variable somewhere, at least when connecting from Linux (but not Windows).
> Should I use the "set link ident" for this?
Are you sure they don't want you to do PPPoE instead of PPTP?
PPPoE requires a name, but PPTP doesn't.
-Archie
__________________________________________________________________________
Archie Cobbs * Packet Design * http://www.packetdesign.com
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-net" in the body of the message
