-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
Bernd Walter wrote:
> OK, when I run conscontrol, it tells me I am using the dcons console. I
> looked at the man page for concontrol (and I've been gone from FreeBSD so
> long, I wasn't even awaare of conscontrol at all) and it informed me I am
> using the dcons device. I am not aware of any others, I was hoping that if
> there were such, there would be references to them in either the dcons or
> conscontrol man pages, but no lock. Is dcons good enough? You understand I
> would be ecstatic if it wasn't 9and if I could set it to something else, and
> thereby get my booting messages back.) I checked my kernel config file, it
> does indeed list the dcons device.
>
>> dcons has no output as such, it depends on further support.
>> dcons for example allows console access over firewire.
>> You likely want consolectl as your configured console device.
>> I can just repeat myself: you must have missing some device hints,
>> since the device as such works fine but is not used as console.
>> See if conscontrol lists consolectl as available console devices,
>> if not than you are surely missing a hint if yes then you have
>> explicitly configured you console to be on dcons.
I wish you'd given more examples, because the concontrol man page is extremely
unhelpful, but I will see if I can prompt you into it, by providing what comes
out of my running conscontrol:
TCSH-april:root:/home/chuckr:#105-12:23>conscontrol
Configured: dcons
Available: dcons,gdb
Muting: off
If you use the "list" parameter to conscontrol, the same printout results. I
*think* you might be saying that I should see something dealing with
consolectl, nothing resu;ting even from man -k consolectl. I did find the
file /dev/consolectl, but I can't figure out the use of it.
Hmmm, I found a hint on an old email, hinting that the command "conscontrol
should have been used to add a console. I just tried using the ctl-alt-f1
combo to get onto ttyv0. I did a tty, this proved I was in fact on ttyv0, so
i tried to do a "conscontrol add /dev/ttyv0, but what came back was "device
not configured". I think I'm close here, so what should my console device be?
>
> Have any other ideas, I'm really listening here.
>
_______________________________________________
freebsd-hackers@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-hackers
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v2.0.4 (FreeBSD)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org
iD8DBQFHbU41z62J6PPcoOkRAhYiAJ0WMob4kfBZFautZJLbbrOm6HVdzQCgjRJ3
+BYHMNjaRLrYjANPsizWeck=
=aUxK
-----END PGP SIGNATURE-----
_______________________________________________
freebsd-hackers@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-hackers
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
