Tom Judge schrieb:
> Mohacsi Janos wrote:
>> Dear All,
>> What is the recommended way to configure vlan interfaces on
>> etherchannel bonded interfaces in a failure mode. I found, that
>> etherchannel is supported by ng_fec(4) (but not exactly what I want)
>> and also found that there two? way of configuring vlans: vlan(4) and
>> ng_vlan(4). But I did not found any description or configuration
>> snippet to configure both preferentially via /etc/rc.conf neither in
>> FreeBSD 6.x-stable, neither in FreeBSD-7.0-current. What I want to
>> achieve:
>>
>> [switch1]-----GE---bge0----\ /----vlan100
>> }=={-----vlan101
>> [switch2]-----FE---bge1----/ \----vlan102
>> \---vlan103
>>
>>
>> I would like to prefer all the vlans via bge0 with GE towards
>> switch1. And use only bge1 in case of switch1 or bge0 link failure.
>>
>> I could use bond on Linux for this purpose. How to achieve similar
>> setup?
>>
>
>
> You may want to take a look at if_lagg, it supports EtherChannel (AKA
> fec), LACP and failover modes (Which is what you would need). It is
> available in RELENG_6 and Current.
If the switches don't support LACP/Fec over two devices use bridge_stp
to simulate a switche and let spanning-tree do the failover.
Arne
_______________________________________________
freebsd-hackers@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-hackers
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
