Hi, Season's greetings to everyone from a rather warm Sydney, Australia!
This evening, I installed a new Promise UltraATA 100 TX2 controller which is correctly recognised at boot time. To this controller I connected a new IBN 60 GB disk (Model: IC35L060AVER07-0). This disk is found and recognised by the Promise controller probe at system startup at Ultra DMA 5 so I believe that the cabling is correct. The problem is that although FreeBSD finds a device present, it does not identify the drive. The output from a "boot -v" is below in case that helps. My entire system was rebuilt from a "cvsup" on December 25 and the system is working fine otherwise it seems. Any advice or thoughts are appreciated - it could be something obvious but as it is after midnight here I am needing sleep! Thanks in advance. Best regards, Shaun. To Unsubscribe: send mail to [EMAIL PROTECTED] with "unsubscribe freebsd-hackers" in the body of the message
