Hello, sound is not working correctly on this IBM model T22 laptop.
Specifically whenever sound plays it is very garbled. I can get it
to play almost correctly via either 'ping -f somehost' or
'dd bs=512 if=/dev/zero of=foo.zero' (well, at least until the filesystem
fills up ;) the ethernet card is on IRQ 11 (same as the sound chip), but
the IDE controller is on the standard IDE IRQ channel... so I am not quite
sure if this is an IRQ issue. This is a -STABLE kernel from today.
--<kernel config>---
machine i386
cpu I686_CPU
ident TTT
maxusers 64
options INET #InterNETworking
options INET6 #IPv6 communications protocols
options FFS #Berkeley Fast Filesystem
options FFS_ROOT #FFS usable as root device [keep this!]
options SOFTUPDATES #Enable FFS soft updates support
options MFS #Memory Filesystem
options MD_ROOT #MD is a potential root device
options NFS #Network Filesystem
options NFS_ROOT #NFS usable as root device, NFS required
options MSDOSFS #MSDOS Filesystem
options CD9660 #ISO 9660 Filesystem
options CD9660_ROOT #CD-ROM usable as root, CD9660 required
options PROCFS #Process filesystem
options COMPAT_43 #Compatible with BSD 4.3 [KEEP THIS!]
options SCSI_DELAY=15000 #Delay (in ms) before probing SCSI
options UCONSOLE #Allow users to grab the console
options USERCONFIG #boot -c editor
options VISUAL_USERCONFIG #visual boot -c editor
options KTRACE #ktrace(1) support
options SYSVSHM #SYSV-style shared memory
options SYSVMSG #SYSV-style message queues
options SYSVSEM #SYSV-style semaphores
options P1003_1B #Posix P1003_1B real-time extensions
options _KPOSIX_PRIORITY_SCHEDULING
options ICMP_BANDLIM #Rate limit bad replies
options KBD_INSTALL_CDEV # install a CDEV entry in /dev
device isa
device pci
# Floppy drives
device fdc0 at isa? port IO_FD1 irq 6 drq 2
device fd0 at fdc0 drive 0
device fd1 at fdc0 drive 1
# ATA and ATAPI devices
device ata0 at isa? port IO_WD1 irq 14
device ata1 at isa? port IO_WD2 irq 15
device ata
device atadisk # ATA disk drives
device atapicd # ATAPI CDROM drives
options ATA_STATIC_ID #Static device numbering
# SCSI peripherals
device scbus # SCSI bus (required)
device da # Direct Access (disks)
device sa # Sequential Access (tape etc)
device cd # CD
device pass # Passthrough device (direct SCSI access)
# atkbdc0 controls both the keyboard and the PS/2 mouse
device atkbdc0 at isa? port IO_KBD
device atkbd0 at atkbdc? irq 1 flags 0x1
device psm0 at atkbdc? irq 12
device vga0 at isa?
# splash screen/screen saver
pseudo-device splash
# syscons is the default console driver, resembling an SCO console
device sc0 at isa? flags 0x100
# Floating point support - do not disable.
device npx0 at nexus? port IO_NPX irq 13
# Power management support (see LINT for more options)
device apm0 at nexus? flags 0x20 # Advanced Power Management
# PCCARD (PCMCIA) support
device card
device pcic0 at isa? irq 0 port 0x3e0 iomem 0xd0000
device pcic1 at isa? irq 0 port 0x3e2 iomem 0xd4000 disable
# Serial (COM) ports
device sio0 at isa? port IO_COM1 flags 0x10 irq 4
device sio1 at isa? port IO_COM2 irq 3
device sio2 at isa? disable port IO_COM3 irq 5
device sio3 at isa? disable port IO_COM4 irq 9
# Parallel port
device ppc0 at isa? irq 7
device ppbus # Parallel port bus (required)
device lpt # Printer
device plip # TCP/IP over parallel
device ppi # Parallel port interface device
#device vpo # Requires scbus and da
device miibus # MII bus support
device fxp # Intel EtherExpress PRO/100B (82557, 82558)
# Pseudo devices - the number indicates how many units to allocate.
pseudo-device loop # Network loopback
pseudo-device ether # Ethernet support
pseudo-device tun # Packet tunnel.
pseudo-device pty # Pseudo-ttys (telnet etc)
pseudo-device md # Memory "disks"
pseudo-device gif 4 # IPv6 and IPv4 tunneling
pseudo-device faith 1 # IPv6-to-IPv4 relaying (translation)
# The `bpf' pseudo-device enables the Berkeley Packet Filter.
# Be aware of the administrative consequences of enabling this!
pseudo-device bpf #Berkeley packet filter
# USB support
device uhci # UHCI PCI->USB interface
device ohci # OHCI PCI->USB interface
device usb # USB Bus (required)
device ugen # Generic
device uhid # "Human Interface Devices"
device ukbd # Keyboard
device ulpt # Printer
device umass # Disks/Mass storage - Requires scbus and da
device ums # Mouse
device uscanner # Scanners
device pcm
--<dmesg>--
Copyright (c) 1992-2001 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD 4.3-STABLE #0: Thu Jul 12 16:49:15 EDT 2001
[EMAIL PROTECTED]:/usr/obj/usr/src/sys/TTT
Timecounter "i8254" frequency 1193182 Hz
CPU: Pentium III/Pentium III Xeon/Celeron (896.11-MHz 686-class CPU)
Origin = "GenuineIntel" Id = 0x68a Stepping = 10
Features=0x383f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SSE>
real memory = 268435456 (262144K bytes)
avail memory = 257523712 (251488K bytes)
Preloaded elf kernel "kernel" at 0xc03a8000.
Pentium Pro MTRR support enabled
md0: Malloc disk
apm0: <APM BIOS> on motherboard
apm: found APM BIOS v1.2, connected at v1.2
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Intel 82443BX (440 BX) host to PCI bridge> on motherboard
pci0: <PCI bus> on pcib0
pcib1: <Intel 82443BX (440 BX) PCI-PCI (AGP) bridge> at device 1.0 on pci0
pci1: <PCI bus> on pcib1
pci1: <S3 model 8c12 graphics accelerator> at 0.0 irq 11
pcic-pci0: <TI PCI-1450 PCI-CardBus Bridge> mem 0x50000000-0x50000fff irq 11 at device
2.0 on pci0
pcic-pci0: TI12XX PCI Config Reg: [ring enable][speaker enable][pwr save][FUNC pci int
+ CSC serial isa irq]
pcic-pci1: <TI PCI-1450 PCI-CardBus Bridge> mem 0x50100000-0x50100fff irq 11 at device
2.1 on pci0
pcic-pci1: TI12XX PCI Config Reg: [ring enable][speaker enable][pwr save][FUNC pci int
+ CSC serial isa irq]
fxp0: <Intel Pro 10/100B/100+ Ethernet> port 0x1800-0x183f mem
0xe8100000-0xe811ffff,0xe8120000-0xe8120fff irq 11 at device 3.0 on pci0
fxp0: Ethernet address 00:03:47:7b:a7:65
inphy0: <i82555 10/100 media interface> on miibus0
inphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
pci0: <unknown card> (vendor=0x11c1, dev=0x045c) at 3.1 irq 11
csa0: <Crystal Semiconductor CS4614/4622/4624 Audio accelerator/4280 Audio controller>
mem 0xe8000000-0xe80fffff,0xe8122000-0xe8122fff irq 11 at device 5.0 on pci0
pcm0: <CS461x PCM Audio> on csa0
isab0: <Intel 82371AB PCI to ISA bridge> at device 7.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel PIIX4 ATA33 controller> port 0x1850-0x185f at device 7.1 on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
uhci0: <Intel 82371AB/EB (PIIX4) USB controller> port 0x1860-0x187f irq 11 at device
7.2 on pci0
usb0: <Intel 82371AB/EB (PIIX4) USB controller> on uhci0
usb0: USB revision 1.0
uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
chip1: <Intel 82371AB Power management controller> port 0x1040-0x104f at device 7.3 on
pci0
orm0: <Option ROMs> at iomem
0xc0000-0xcbfff,0xcc000-0xcd7ff,0xdc000-0xdffff,0xe0000-0xeffff on isa0
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model Generic PS/2 mouse, device ID 0
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
pcic0: <Intel i82365SL-DF> at port 0x3e0 iomem 0xd0000 on isa0
pcic0: Polling mode
pccard0: <PC Card bus (classic)> on pcic0
pccard1: <PC Card bus (classic)> on pcic0
sio0: configured irq 4 not in bitmap of probed irqs 0
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 8250
sio1: configured irq 3 not in bitmap of probed irqs 0
ppc0: cannot reserve I/O port range
ad0: 30520MB <IBM-DJSA-232> [66144/15/63] at ata0-master UDMA33
acd0: DVD-ROM <MATSHITADVD-ROM SR-8175> at ata1-master using PIO4
Mounting root from ufs:/dev/ad0s3a
WARNING: / was not properly dismounted
pid 405 (dd), uid 1001 on /: file system full
--
David Cross | email: [EMAIL PROTECTED]
Lab Director | Rm: 308 Lally Hall
Rensselaer Polytechnic Institute, | Ph: 518.276.2860
Department of Computer Science | Fax: 518.276.4033
I speak only for myself. | WinNT:Linux::Linux:FreeBSD
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-hackers" in the body of the message
