Jesús Arnáiz wrote:
>
> Hi everyone.
>
> I have installed FreeBSD 4.2 on my laptop and it has a a PCMCIA ethernet adapter. It
> is a L100C32 Dynalink 10/100Mbps 32bit Ethernet Adapter.
>
> The system don't find it when it boots (I think). I use all the PCMCIA options to
> BOOT, and I when I use ifconfig I see this interfaces:
>
> faith0
> gif1
> gif2
> gif3
>
> (And also, lp0, and so on).
>
> But no one work. How can i fix it and make my ethernet adapter work.
You can't make it work with PCMCIA because it isn't a PCMCIA card. Notice
where you wrote "32-bit" above? That means it is a *CardBus* card. Sorry,
4.x doesn't play that tune.
FreeBSD-Current has some support for CardBus, but:
a) I doubt you'll find the "Dynalink L100C32" supported (yet), and
b) Current is pretty scary at the moment.
--
"Where am I, and what am I doing in this handbasket?"
Wes Peters Softweyr LLC
[EMAIL PROTECTED] http://softweyr.com/
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-hackers" in the body of the message