I'm glad to hear that i'm not the only one with this problem, but unfortunatley i don't have any more PCI cards, and i need to have the second subnet up by the end of this week. Is it possoble that there is some kind of bug in the new source ? i will run cvsup again today (it takes me about 10 hours to download and compile the source :( .... I hope it will work again. If there is anyone who knows more about this please let me know. Thanks Fenix. +;-----Original Message----- +;From: Karel J. Bosschaart [mailto:[EMAIL PROTECTED]] +;Sent: Thursday, June 22, 2000 3:59 PM +;To: FENIX +;Cc: FreeBSD Questions +;Subject: Re: CVSUP and hardware problem +; +; +;On Thu, Jun 22, 2000 at 03:40:58PM +0200, FENIX wrote: +;> I have recently cvsup'ed my 4.0-INSTALL to 4.0-STABLE , after +;all was done i +;> made a new kernel and , now it hangs on the boot , i got 2 +;NE2000 adapters +;> (ed0 ed1) and one 3com (xl) it all worked fine before the +;cvsup, but now it +;> hangs on ed1 while booting, i haven't changed anything in the +;kernel config +;> file i just made a new kernel with new sources (i also deed +;make clean for +;> the kernel), when i boot -c and disable ed1 it works fine . Does someone +;> know why it's happening ? +;> +;Unfortunately I don't know what's happening, but yesterday I had the same +;problem as you: An NE2000 (ISA, non-PnP) caused 4.0-Stable to hang during +;boot unless ed0 is disabled, while 4.0-Release booted without +;problems (and +;the 4.0-Release floppies still boot and detect the ed0 properly). +;I replaced +;the ISA card with a PCI card and it works again in 4.0-Stable, +;also using ed0. +; +;Karel. +; To Unsubscribe: send mail to [EMAIL PROTECTED] with "unsubscribe freebsd-hackers" in the body of the message
