On Thu, 22 Jun 2000, Juan Lorenzana wrote:
> We have an onboard SCSI controller which we use to talk to the local disk. We
> have installed two Adaptec 2940U2W as well. One that talks directly to the RAID
> and another that talks to a tape device. When we run in this configuration, we
> get the following error:
>
> /kernel: (sa1:ahc1:0:3:0):scb 0x2F timed out in dataout phase, scsisigi == 0x4
>
> This only happens during high traffic situation, like when we do our daily
> backups. I have searched the newsgroups and have not found any insight as to
> what might be the problem and it's resolution. We had to install the CAM
> drivers in order to support the Adaptec 2940U2W card. I only found one other
> instance of this problem, but no one had responded.
Double-check your termination and cabling. Trouble during high activity
is probably some sort of interference. It also could be a device that
just can't take the heat.
Doug White | FreeBSD: The Power to Serve
[EMAIL PROTECTED] | www.FreeBSD.org
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-hackers" in the body of the message
