Hi,
I have a question for the networking gurus out there. How exactly would you
configure a FreeBSD machine connected to a Cisco switch with port grouping on
two Ethernet channels?
Also, for future reference, the funny network delays on the switched network
were solved. It turns out if you force the switch to 100/full on the port, the
Intel PRO 100/B card will run at 100/half, since it assumes the switch is a
non-autonegotiating hub. Use auto select on both sides works very well.
Yann
--
--------------------------------------------------------------------
Yann Ramin [EMAIL PROTECTED]
Atrus Trivalie Productions www.atrustrivalie.eu.org
irm.it.montereyhigh.com
Monterey High IT www.montereyhigh.com
ICQ 46805627
AIM oddatrus
Marina, CA
"All cats die. Socrates is dead. Therefore Socrates is a cat."
- The Logician
# fortune
"To be responsive at this time, though I will simply say, and therefore
this is a repeat of what I said previously, that which I am unable to
offer in response is based on information available to make no such
statement."
--------------------------------------------------------------------
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-hackers" in the body of the message
