Mike Smith wrote:
> > So, I want to know how I can "automagically" set the device options,
> > every time a user kldload's the device driver.
>
> If you want to support this mode of operation, you really don't have a
> lot of options right now.
> Well, teaching kldload about module parameters would make it into 4.1, if
> that's good enough.
Well, unless there are some of you out there that have Lucent WildWire cards
*and* compatible DSL service, and you just can't wait to get a driver, I can
wait a little while... ;-) That is, presuming you meant "_should_ make it
into 4.1" :), which isn't *that* far away...
When and where should I look for information on how "module parameters"
work? (I don't have the time or resources to run both 4.x and -current)
BTW, there *are* hundreds of thousands of the boards out there in Compaq,
Dell, and HP computers, but most of them are being used only as V.90
Winmodems for the time being -- the boards can do either V.90 or DSL with
the appropriate driver, though not simultaneously...
Thanks,
Gary
--
=========================================================
Gary Corcoran - Distinguished Member of Technical Staff
Lucent Microelectronics - Client Access Broadband Systems
Communications Protocol & Driver Development Group
"We make the drivers that make communications work"
Email: [EMAIL PROTECTED]
---------------------------------------------------------
There are only two kinds of machines - those that fail
little by little, and those that fail all at once.
=========================================================
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-hackers" in the body of the message
