-----BEGIN PGP SIGNED MESSAGE-----
On 28-Jan-00 Matthew N. Dodd wrote:
> On Fri, 28 Jan 2000, Corey Leopold wrote:
> ...
>
> What is the board connected to? Hub? Switch? Can you specify media
> settings manually?
>
I've had it on a cross-over cable with a 100MB sparc on the other end, and also
a 100MB Cisco Hub.
Specifing the media settings doesn't change things. Also autoselect selects
right (eg. 100baseTX full-duplex with the cross-over, and 100baseTX half-duplex
with the hub.) I also tried 10baseT/UTP settings these don't work either.
If I run tcpdump I can see arp traffic going out from the machine but I never
see any other traffic.
If I couldn't just boot into a single processor kernel and it worked, I would
suspect that it is a bad cable.
Thanks
Corey
- ----------------------------------
Corey Leopold
E-Mail: Corey Leopold <[EMAIL PROTECTED]>
Phone (210)-925-3459
- ----------------------------------
-----BEGIN PGP SIGNATURE-----
Version: PGPfreeware 5.0i for non-commercial use
Charset: noconv
iQCVAwUBOJH23T3+cS8MmLXZAQEqDAP/cZAGVvXX5Jh5l6mPcXceGRmLu0P9vQvH
623nNV3LDwAZwCwxNqfQyI6AGg6D7yeNZqY5SAa67jc35PONViiRbf55aVo0LFj/
/7ltw14uxAwcemnY+d+OzgaXf+fsOzw97AddhAzM8D1u+WZJA4va2lJgzcLhc42b
qSqkYNtrt8U=
=B2JB
-----END PGP SIGNATURE-----
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-hackers" in the body of the message
