I have been writing a nasty kludge to treat a CardBus bridge as a standard
PCI bridge (with static config) <you may start throwing rocks now>. I have
it to the point where I can (after the system is booted) 'pciconf -r
pci5:0:0 0' and get scan information (neat, huh :). Welll, I thought it would
then just be a simple matter of 'device_add_child(dev, "pci", 5, 0);' to get
the bus to show up at PCI5: at bootup, but it seems to ignore it. following
from pcisupport.c I also tried to 'bus_generic_attach()' it after
device_add_child() finished. no go. Any suggestions?
--
David Cross | email: [EMAIL PROTECTED]
Systems Administrator/Research Programmer | Web: http://www.cs.rpi.edu/~crossd
Rensselaer Polytechnic Institute, | Ph: 518.276.2860
Department of Computer Science | Fax: 518.276.4033
I speak only for myself. | WinNT:Linux::Linux:FreeBSD
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-hackers" in the body of the message
