I hope this is the right place to post, sorry if it's not.
I'm really sorry to post what is probably a repeat question, but I've just
upgraded to freebsd 3.2-release and I'm having real problems getting the
kernel to see my printer ports:
here is my kernel
device ppc0 at isa? port? flags 0x40 net irq 7
controller ppbus0
device lpt0 at ppbus?
device plip0 at ppbus?
device ppi0 at ppbus?
and here is my dmesg output:
ppc0 at 0x3bc irq 7 flags 0x40 on isa
ppc0: Generic chipset (ECP/PS2/NIBBLE) in COMPATIBLE mode
ppi0: <generic parallel i/o> on ppbus 0
plip0: <PLIP network interface> on ppbus 0
whenever I try to access lpt0 it says that the device is not configured.
If I try and use the old configuration of lpt and I try and build the kernel
I get a whole load of make errors.
what am I doing wrong!?
please help
thanks
Alex
P.S. I'm not actually subscribed to the mailing list, so can you reply to
me.
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-hackers" in the body of the message
