Thanks a Lot Gary for writting in the list the errors... I thought the image could be sent here..
Thanks too for your help mate 👍 Egoitz, > El 9 feb 2019, a las 17:42, Gary Aitken <a...@dreamchaser.org> escribió: > >> On 2/7/19 11:50 AM, Egoitz Aurrekoetxea wrote: >> >> I recently resized a GEOM partition in FreeBSD 11.1. It was a vm, so I >> increased the disk size at hypervisor level, later did a gpart recover, >> gpart resize -i partition, and growfs -y... >> The disk was configured as : >> gpart show >> => 40 1048575920 ada0 GPT (500G) >> 40 1024 1 freebsd-boot (512K) >> 1064 8388608 2 freebsd-swap (4.0G) >> 8389672 1040186288 3 freebsd-ufs (496G) >> The 496GB partition was the only increased one (from 200 to 500). All it >> was done in a livecd of FreeBSD 11.2. I finally been able to with that >> steps to increase the partition, but I'm worried about some errors >> received : >> I think perhaps they could be just some surely to ignore erros as the >> steps given, are the ones described in Handbook (except sysctl >> kern.geom.debugflags=16) which I didn't launch because I was using a >> livecd and by the way a non mounted file system. >> Should I worry about them?. The server is working and the filesystems >> mounted... >> root@web01c:~ # gpart status >> Name Status Components >> ada0p1 OK ada0 >> ada0p2 OK ada0 >> ada0p3 OK ada0 >> What do you think about it?. >> On 2/9/19 4:03 AM, Egoitz Aurrekoetxea wrote: >> >> Hi Gary. >> I attach you the screenshot > >> El 08-02-2019 23:42, Gary Aitken escribió: >>> On 2/8/19 1:59 AM, Egoitz Aurrekoetxea wrote: >>>> I attach the errors shown... >>> >>> There were no errors shown or attached on the message I received. > >> On 2/9/19 4:03 AM, Egoitz Aurrekoetxea wrote: >> >> I attach you the screenshot > > Unfortunately, I don't know enough to be of any help here. > > The screenshot shows messages of the form: > g_access(944): provider ufsid/xxxxx has error 6 set > followed by > g_access(944): provider gptid/yyyyy has error 6 set > and then > g_dev_taste: make_dev_p() failed (gp->name=gptid/yyyyy, error=17) > I don't know what this error 6 is and don't know anything about g_access; > but if it is from sys/errno.h that would be ENXIO, Device not configured. > > I suspect it has something to do with running under the vm but that is a > wild guess. > I don't monitor the freebsd-geom mailing list but hopefully someone there > can assist. > > Gary > _______________________________________________ > freebsd-geom@freebsd.org mailing list > https://lists.freebsd.org/mailman/listinfo/freebsd-geom > To unsubscribe, send any mail to "freebsd-geom-unsubscr...@freebsd.org" _______________________________________________ freebsd-geom@freebsd.org mailing list https://lists.freebsd.org/mailman/listinfo/freebsd-geom To unsubscribe, send any mail to "freebsd-geom-unsubscr...@freebsd.org"
