On Tue, 21 Oct 2003, Lukas Ertl wrote:
> I just found that the em0 interface in one of my boxes stopped working
> after an upgrade from 5.1-RELEASE to 5.1-CURRENT, this is what the kernel
> spits out:
>
> $ dmesg | grep em0
> em0: <Intel(R) PRO/1000 Network Connection, Version - 1.7.16> port
> 0xb000-0xb03f mem 0xe2000000-0xe201ffff irq 12 at device 5.0 on pci2
> em0: [MPSAFE]
> em0: The EEPROM Checksum Is Not Valid
> em0: Unable to initialize the hardware
> device_probe_and_attach: em0 attach returned 5
Oh, I forgot to add, this is what pciconf has to say about it:
[EMAIL PROTECTED]:5:0: class=0x020000 card=0x002e8086 chip=0x100e8086 rev=0x02
hdr=0x00
vendor = 'Intel Corporation'
device = '82544XT PRO/1000 MT Gigabit Ethernet Controller'
class = network
subclass = ethernet
A solution would be highly appriciated.
regards,
le
--
Lukas Ertl eMail: [EMAIL PROTECTED]
UNIX Systemadministrator Tel.: (+43 1) 4277-14073
Vienna University Computer Center Fax.: (+43 1) 4277-9140
University of Vienna http://mailbox.univie.ac.at/~le/
_______________________________________________
[EMAIL PROTECTED] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-current
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
