On Thu, 5 Jun 2003 16:14:25 +0200, Alexander Leidinger <[EMAIL PROTECTED]> wrote:
Hi,
is there a way to teach our ACPI implementation about
[EMAIL PROTECTED]:7:4: class=0x068000 card=0x00000000 chip=0x30571106 rev=0x40 hdr=0x00
vendor = 'VIA Technologies Inc'
device = 'VT82C686A/B ACPI Power Management Controller'
class = bridge
subclass = PCI-unknown
Oh, it seems to be little different but I have the same 'VT82C686A/B ACPI Power Management Controller'..
===============================
[EMAIL PROTECTED]:7:4: class=0x0c0500 card=0x30571106 chip=0x30571106 rev=0x40 hdr=0x00
vendor = 'VIA Technologies Inc'
device = 'VT82C686A/B ACPI Power Management Controller'
class = serial bus <-- diff here..
subclass = SMBus <-- diff here..
===============================
Cheers, Mezz
I own the same chipest here, which it is support in 4.x and no longer in 5.x.. :-( Note that, I only check in the 5.x's NOTES and haven't tried to put some opinion from 4.x to 5.x yet. I don't know if it will work.
In 4.x, you just add in the kernel config following:
=============================== # VT82C686A/B ACPI Power Management Controller device smbus device viapm
device iicbus device iicbb
device ic device iic device iicsmb ===============================
I would like to see someone to bring 4.x drivers to 5.x as well. Too bad, I know nothing with C, but just a hello world.
Cheers, Mezz
Bye, Alexander.
-- bsdforums.org 's moderator, mezz. _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-current To unsubscribe, send any mail to "[EMAIL PROTECTED]"
