Works just fine.
dmesg output:
Copyright (c) 1992-2002 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD 5.0-CURRENT #3: Sat Aug 17 16:48:56 EDT 2002
[EMAIL PROTECTED]:/usr/src/sys/sparc64/compile/OBERON
Preloaded elf kernel "/boot/kernel/kernel" at 0xc040a000.
Timecounter "tick" frequency 502000000 Hz
cpu0: Sun Microsystems UltraSparc-IIe Processor (502.00 MHZ CPU)
nexus0: <OpenFirmware Nexus device>
pcib0: <U2P UPA-PCI bridge> on nexus0
pcib0: sabre: impl 0, version 0: ign 7c0 DVMA map: 0xc0000000 to 0xdfffffff
device 0/12/0: latency timer 64 -> 82
pcib0: ofw_pci_init: no interrupt mapping found for 0/12/0 (preset 0)
pcib0: ofw_pci_init: no interrupt mapping found for 0/7/0 (preset 0)
device 0/12/1: latency timer 64 -> 82
pcib0: ofw_pci_init: mapping intr for 0/12/1 to 6 (preset was 0)
device 0/12/2: latency timer 64 -> 82
pcib0: ofw_pci_init: mapping intr for 0/12/2 to 28 (preset was 0)
device 0/12/3: latency timer 64 -> 82
pcib0: ofw_pci_init: mapping intr for 0/12/3 to 36 (preset was 0)
pcib0: ofw_pci_init: no interrupt mapping found for 0/3/0 (preset 0)
device 0/8/0: latency timer 64 -> 16
pcib0: ofw_pci_init: mapping intr for 0/8/0 to 35 (preset was 0)
device 0/13/0: latency timer 64 -> 16
pcib0: ofw_pci_init: mapping intr for 0/13/0 to 12 (preset was 0)
PCI-PCI bridge at 0/5/0: setting bus #s to 0/1/1
pcib0: ofw_pci_init: descending to subordinate PCI bus
device 0/19/0: latency timer 64 -> 66
pcib0: ofw_pci_init: mapping intr for 0/19/0 to 15 (preset was 15)
pci0: <PCI bus> on pcib0
pci0: <old, non-VGA display device> at device 3.0 (no driver attached)
pcib1: <PCI-PCI bridge> at device 5.0 on pci0
pci1: <PCI bus> on pcib1
isab0: <PCI-ISA bridge> at device 7.0 on pci0
isa0: <ISA bus> on isab0
pci0: <multimedia, audio> at device 8.0 (no driver attached)
ebus0: revision 0x01
ebus0: <idprom>: incomplete
ebus0: <PCI-EBus3 bridge> mem 0xf1000000-0xf17fffff,0xf0000000-0xf0ffffff at dev
ice 12.0 on pci0
ebus0: <flashprom> addr 0-0xfffff (no driver attached)
eeprom0: <EBus EEPROM/clock> addr 0x100000000-0x100001fff on ebus0
eeprom0: model mk48t59
eeprom0: hostid 809fd225
gem0: <Sun ERI 10/100 Ethernet Adaptor> mem 0x400000-0x41ffff irq 6 at device 12
.1 on pci0
miibus0: <MII bus> on gem0
ukphy0: <Generic IEEE 802.3u media interface> on miibus0
ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
gem0: Ethernet address: 08:00:20:9f:d2:25, 2KB RX fifo, 2KB TX fifo
using internal phy
pci0: <serial bus, FireWire> at device 12.2 (no driver attached)
pci0: <serial bus, USB> at device 12.3 (no driver attached)
atapci0: <AcerLabs Aladdin ATA66 controller> port 0xa20-0xa2f,0xa08-0xa0b,0xa10-
0xa17,0xa18-0xa1b,0xa00-0xa07 irq 12 at device 13.0 on pci0
ata2: at 0xa00 on atapci0
ata3: at 0xa10 on atapci0
pci0: <display, VGA> at device 19.0 (no driver attached)
Timecounters tick every 10.000 msec
Initializing GEOMetry subsystem
ad0: 19092MB <ST320011A> [38792/16/63] at ata2-master UDMA66
ad1: 38172MB <MAXTOR 6L040J2> [77557/16/63] at ata3-master UDMA66
Mounting root from ufs:/dev/ad1a
Invalid time in real time clock.
Check and reset the date immediately!
regards,
--
wca
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-current" in the body of the message
