On Fri, Sep 06, 2002 at 06:09:59PM +0200, Bernd Walter wrote: > On Sat, Sep 07, 2002 at 12:05:54AM +0900, Shunsuke Akiyama wrote: > > Hi, > > > > At Thu, 5 Sep 2002 16:17:42 +0200, > > Bernd Walter wrote: > > > > > I've build a device which is based on the FT8U232AM chip. > > > Probing works like a charm: > > > [81]cicely13# usbdevs -v | grep FTDI > > > port 3 addr 5: full speed, power 90 mA, config 1, USB <-> Serial(0x6001), >FTDI(0x0403), rev 2.00 > > > And I get a new node in /dev: > > > [82]cicely13# ls -l /dev/ucom0 > > > crw-rw---- 1 uucp dialer 138, 128 Sep 4 16:43 /dev/ucom0 > > > But I get an error when writing: > > > [83]cicely13# echo test > /dev/ucom0 > > > /dev/ucom0: Device not configured. > > > [84]cicely13# uname -a > > > FreeBSD cicely13.cicely.de 5.0-CURRENT FreeBSD 5.0-CURRENT #3: Wed Sep 4 >15:54:17 CEST 2002 >[EMAIL PROTECTED]:/var/d7/builder/FreeBSD-2002-08-31/src/sys/i386/compile/CICELY13 > i386 > > > > I've got a similar problem report with uvscom. And I also have this > > problem, too. > > Good to hear that others have this problem too. > I wasn't shure if it's my fault buildung the device or the driver. > > > Please try to attached patch. > > It's works fine for me. > > Are you shure? > The patch just changes the name of the drivers. > Not surprisingly it did not solve my problem.
Amazing - it works now if the device is plugged in at booting. -- B.Walter BWCT http://www.bwct.de [EMAIL PROTECTED] [EMAIL PROTECTED] To Unsubscribe: send mail to [EMAIL PROTECTED] with "unsubscribe freebsd-current" in the body of the message
