I'm running current and get the following error in dmesg while trying to
enable the minipci. This is a HP n5470 laptop.
dc0: <Accton EN2242 MiniPCI 10/100BaseTX> irq 11 at device 16.0 on pci0
dc0: failed to enable I/O ports!
device_probe_and_attach: dc0 attach returned 6
It is sharing irq 11 with the cardbus bridge. As I understand this sharing
should work but I have my doubts. To double check I have tried to change the
cardbus too use irq 10 by changing hints to irq 10 and by adding
machdep.pccard.pcic_irq="10"
to loader.conf. They don't make any chnge. So I haven't been able to confirm
my suspisions. Does anyone have a suggestion as to how I might be able to
test this or fix it (would be even better:)?
Thanks,
ed
pcic0: <TI PCI-1420 PCI-CardBus Bridge> mem 0x44000000-0x44000fff irq 11 at
device 4.0
on pci0
pcic0: Memory mapped device, will work.
pcic0: TI12XX PCI Config Reg: [ring enable][speaker enable][pwr save][pci only]
pccard0: <PC Card bus (classic)> on pcic0
pcic1: <TI PCI-1420 PCI-CardBus Bridge> mem 0x44001000-0x44001fff irq 11 at
device 4.1
on pci0
-----------------------------------------------------------------------
The illiterate of the 21st century will not be
those who cannot read and write,
but those who cannot learn, unlearn and relearn.
--Alvin Toffler
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-current" in the body of the message
