I am experiencing a strange lockup with -current as of about a week
ago: It will suspend and resume, but after the resume the console is
dead and the system hangs after a short while.
When I type on the console after a resume, nothing is shown, neither
echo nor command output. If I break into DDB, the output suddenly
appears, just above the DDB prompt. I can continue to UNIX, type
another command, again nothing visible. Breaking into DDB again shows
what I typed, and the output. After a few round-trips of this sort
the system locks up solidly.
If I'm in X (XFree86-4.0.2) after the resume, the system will respond
for a few seconds and then lock up.
All this happens with the GENERIC kernel as well as my cardbus kernel.
Should I assume the console needs resetting after the resume? How
could I try a reset? I can't find anything obvious in vidcontrol(1)
or kbdcontrol(1).
Hardware is a Dell Inspiron 7500.
--
Regards,
Georg.
----------------------------------------------------------------------
Who in the world needs 2000 Windows?
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-current" in the body of the message
