On 2015-Apr-1, at 08:12 PM, Kevin Oberman <rkoberman at gmail.com> wrote: > > On Wed, Apr 1, 2015 at 12:08 PM, Mark Millard <markmi at dsl-only.net> wrote: > I rebuilt and the boot-message line > > > Mar 31 17:20:08 FBSDG5C0 ntpd[775]: line 22 column 1 syntax error > > > is no longer is occurring. But I'm still getting the other two: > > > Mar 31 17:20:08 FBSDG5C0 ntpd[775]: setsockopt IPV6_MULTICAST_IF 0 for > > [omitted] fails: Can't assign requested address > > Mar 31 17:20:08 FBSDG5C0 ntpd[775]: setsockopt IPV6_MULTICAST_IF 0 for > > [omitted] fails: Can't assign requested address > > > === > Mark Millard > markmi at dsl-only.net > > This is probably way too obvious, but is the system configured for IPv6? > -- > Kevin Oberman, Network Engineer, Retired > E-mail: rkober...@gmail.com >
I do not know how much the two messages matter --for me or to anyone else. They might not be interesting other than my being educated a bit. As for what all is non-default for my configuration files (not much)... My use of networking is minimal and the configuration changes for that are limited to rc.conf: > # more /etc/rc.conf > hostname="FBSDG5C0" > ifconfig_bge0="DHCP" > ifconfig_bge0_ipv6="inet6 accept_rtadv" > ifconfig_gem0="DHCP" > ifconfig_gem0_ipv6="inet6 accept_rtadv" > sshd_enable="YES" > ntpd_enable="YES" > ntpd_sync_on_start="YES" > # Set dumpdev to "AUTO" to enable crash dumps, "NO" to disable > dumpdev="AUTO" > hald_enable="YES" > dbus_enable="YES" Historically I've used 10.1-STABLE that way and still do. Recently I've been experimenting with 11.0-CURRENT based on the same sort of /etc/rc.conf file. I'm not getting the notices for 10.1-STABLE and have not been. I am getting the notices for 11.0-CURRENT now but I did not notice such with the few earlier-vintage builds that I've done. It is possible that I just did not notice: I do not have much 11.0-CURRENT history. If so, then my notes are more of a 10.1-STABLE vs. 11.0-CURRENT difference notice. I also fiddle with /boot/loader.conf, /etc/fstab, /etc/make.conf, and /etc/src.conf primarily. /etc/sysctl.conf for dump issues. /usr/local/etc/sudoers . The rest of the configuration files are at the default/installation status. The PowerMac that I plug the SSD into at the time determines which of bge0 vs. gem0 actually exists. === Mark Millard markmi at dsl-only.net _______________________________________________ freebsd-current@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-current To unsubscribe, send any mail to "freebsd-current-unsubscr...@freebsd.org"
