hi,
is there anyone who knows how i can test vlan feature using *etherswitchcfg*,
it tried to set and get vlan configuration for chip ar8316 it shows me
right output like
#etherswitchcfg
port0:
vlangroup: 1
media: Ethernet 1000baseT <full-duplex>
status: active
port1:
vlangroup: 1025
media: Ethernet autoselect (none)
status: no carrier
port2:
vlangroup: 1
media: Ethernet autoselect (none)
status: no carrier
port3:
vlangroup: 1
media: Ethernet autoselect (none)
status: no carrier
port4:
vlangroup: 1
media: Ethernet autoselect (none)
status: no carrier
vlangroup0:
vlan: 0
members 1t,2t,3t,4t
vlangroup1:
vlan: 1
members 2
vlangroup2:
vlan: 0
members 0t,1t,3t,4t
vlangroup3:
vlan: 0
members 0t,1t,2t,4t
vlangroup4:
vlan: 0
members 0t,1t,2t,3t
vlangroup5:
vlan: 0
members 0t,1t,2t,3t,4t
but i still dont know how i should test it with its limited commands.i have
used vlan feature on a NetGear switch, i still can find how i can assign
LAN IP to a vlan and use it later...
Plz anyone who knows i can test vlan feature with this.
Thanks
_______________________________________________
freebsd-current@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-current
To unsubscribe, send any mail to "freebsd-current-unsubscr...@freebsd.org"
