Hi.
On 13.08.2011 23:56, Michael Butler wrote:
I tried to mount a card from my phone (it's quicker to copy directly
than through USB) but I get this .. what am I missing here?
Aug 13 16:53:37 toshi kernel: sdhci0-slot0: Card inserted
Aug 13 16:53:37 toshi kernel: mmc0:<MMC/SD bus> on sdhci0
Aug 13 16:53:37 toshi kernel: mmc0: Probing bus
Aug 13 16:53:37 toshi kernel: mmc0: SD probe: OK (OCR: 0x00ff8000)
Aug 13 16:53:37 toshi kernel: mmc0: Current OCR: 0x00ff8000
Aug 13 16:53:38 toshi kernel: mmc0: Probing cards
Aug 13 16:53:38 toshi kernel: mmc0: New card detected (CID
03534453553136478080d4290400a300)
Aug 13 16:53:38 toshi kernel: mmc0: Card at relative address 36832 added:
Aug 13 16:53:38 toshi kernel: mmc0: card: SD High Capacity
(0x3/0x5344/"SU16G" rev 8.0 m/d 03.2010 s/n 80d42904)
Aug 13 16:53:38 toshi kernel: mmc0: bus: 4bit, 50MHz, high speed timing
Aug 13 16:53:38 toshi kernel: mmc0: memory: 31116288 blocks, erase
sector 8192 blocks, read-only
Aug 13 16:53:38 toshi kernel: mmc0: setting transfer rate to 30.000MHz
Aug 13 16:53:38 toshi kernel: mmcsd0: 2905MB<SDHC Memory Card>
(read-only) at mmc0 24MHz/4bit
Aug 13 16:53:38 toshi kernel: GEOM: new disk mmcsd0
Aug 13 16:53:38 toshi kernel: mmc0: setting bus width to 4 bits
vvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvv
Aug 13 16:53:38 toshi kernel: GEOM_PART: partition 1 has end offset
beyond last LBA: 31116287> 5950463
Aug 13 16:53:38 toshi kernel: GEOM_PART: integrity check failed (mmcsd0,
MBR)
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
It looks like consequence of r222475. Could you try this patch:
--- dev/mmc/mmcsd.c.prev 2011-08-14 14:09:35.000000000 +0300
+++ dev/mmc/mmcsd.c 2011-08-14 14:09:14.000000000 +0300
@@ -137,7 +137,7 @@ mmcsd_attach(device_t dev)
d->d_drv1 = sc;
d->d_maxsize = 4*1024*1024; /* Maximum defined SD card AU
size. */
d->d_sectorsize = mmc_get_sector_size(dev);
- d->d_mediasize = mmc_get_media_size(dev) * d->d_sectorsize;
+ d->d_mediasize = (off_t)mmc_get_media_size(dev) * d->d_sectorsize;
d->d_stripeoffset = 0;
d->d_stripesize = mmc_get_erase_sector(dev) * d->d_sectorsize;
d->d_unit = device_get_unit(dev);
--
Alexander Motin
_______________________________________________
freebsd-current@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-current
To unsubscribe, send any mail to "freebsd-current-unsubscr...@freebsd.org"
